How Do I Start My Hunter Pro C Sprinkler System?

Pro-C – One Touch Manual Start and Advance With the dial in the RUN position, hold down the button for 2 seconds. This feature automatically defaults to program A. You can select program B, or C by pressing the PRG program. The station number will be flashing. Press the button to scroll to the station you wish to begin with.

How Do I Test My Hunter Pro C Sprinkler System?

To initiate the test program:

Press and hold the PRG button. The station number will be flashing. Press the (<=) or (=>) button to scroll to the station you would like the test program to start with. Use the (+) and (-) buttons to set a runtime of up to 15 minutes. After a 2 second pause, the test program will begin.

How Far Can I Run Sprinkler Wire?

Most manufacturers include recommendations about what wire size to use with their valves, but typically, you can use 18-gauge wire if the length of the wire (not the distance) from the controller to the valve is less than 200 feet, and it’s being installed as a residential system.

How Do You Winterize A Hunter Pro C Sprinkler System?

To start the blow out, shut off the irrigation water supply and, with the compressor valve in the closed position, attach the air compressor hose to the fitting. Activate the station on the controller that is the zone or sprinklers highest in elevation and the furthest from the compressor.

What Does No Ac Mean On A Sprinkler System?

The “NO AC” display is a diagnostic message telling you that the controller has stopped receiving AC power. The controller is running on the power supplied by the backup battery. Check the power source by plugging a lamp or radio into the wall outlet to verify there is power at the outlet.

What Is Hunter Pro C?

The Hunter Pro C Series is your cost-effective irrigation controller. And if you elect to have the new Solar Sync as a running mate, the PCC is designed for the sensor to be installed directly in the controller cabinet, for a compact, coordinated sprinkler system.

How Do You Test A Hunter Node?

Make sure the controller is in Idle Mode. Press and hold the PRG button until the icon is displayed. The station number will be displayed in the lower left side of the display along with the run time. Quickly press the plus or minus buttons to set the duration of watering time for the test program.

How Long Should You Water Your Grass?

Usually it’s about 30 minutes. So 20 minutes, 3 times per week will get an inch of water on your lawn, and 30 minutes 3 times per week will get 1 ½” down. Bear in mind that during extreme heat, you will need to water more, due to evaporation and heat stress on the grass.

How Do You Turn Off A Hunter Sprinkler System?

To put the Node battery powered sprinkler timer in the off mode, use the center button to advance to the off screen and allow the controller to go to sleep in that position. To turn the controller back on, use the center button to return to the home screen and allow the controller to go to sleep in that position.

Why Does My Sprinkler System Keep Running?

There are two reasons why your sprinklers would continue running: It’s possible your valves have been opened manually. You’ll need to locate your valve box(es) and turn the solenoid(s) clockwise until snug. The solenoid is located on the top of the valve and looks like a cylinder with two wires protruding out of it.