How Do You Change The Drive Belt On A Husqvarna Riding Lawn Mower?


How Do You Adjust The Drive Belt On A Riding Lawn Mower?

How to Tighten a Riding Lawnmower Belt

Turn off the engine of your lawnmower and disconnect the spark plug wire as well. Locate the main frame tube on your lawnmower. Locate the belt, also known as the drive belt, inside the deck of your lawnmower. Tighten the belt of your lawnmower by shortening the location of the main frame inside the clamps.

How Do You Adjust The Belt Tension On A Husqvarna Riding Lawn Mower?

How to Adjust the Belt on the Husqvarna YTH20K46

Turn on the mower via the ignition switch located in the lower-right-hand corner of the panel just below the steering wheel. Press the parking brake pedal located on the left side footrest. To set the parking brake, push down hard on the brake pedal. Locate the log lever extending from the top of the control panel.

How Do You Purge A Hydrostatic Transmission?

Push motion control levers forward all the way and hold for five seconds. Pull motion control levers to full reverse position and hold for five seconds. Repeat steps 6 and 7 three times. This purges any air from the hydraulic transmission system.

What Does The Drive Belt Do On A Riding Mower?

The ground drive belt connects the engine crankshaft to the transaxle pulley to drive the rear wheels. If the belt breaks, the lawn tractor won’t move. If the belt is worn, the lawn tractor moves sluggishly because the belt slips on the pulley.

Why Does My Belt Keep Slipping Off My Lawn Mower?

The drive belt may come off a riding mower because it is damaged or loose. Even when it does not fall off, such a belt poses dangers. When loose, the belt may slip, resulting in friction that, if it creates enough heat, can lead to a fire in the mower’s engine.