How Do You Load A Porter Cable Brad Nail Gun?

How to Load a Porter Cable Finishing Nail Gun Check that the trigger is not activated. Point the nose of the gun away from your body and away from any bystanders. Slide a new clip of finish nails through the T-shaped opening at the rear of the magazine.

How Do You Fix A Porter Cable Nail Gun?

For this repair, we used a Porter Cable nail gun.

This may make them difficult to remove and is normal.

Remove the nail gun head. Remove the magazine. Remove the nose piece. Remove the cylinder assembly. Remove the piston and bumper. Replace the cylinder o-rings. Replace the piston o-ring. Replace the alignment ring o-ring.

Why Is My Nail Gun Not Firing?

Possible causes for a Paslode nail gun not firing are: A nail jam is stopping the nails from moving forward. The gas fuel cell is empty, out-of-date or not attached properly. The nailer needs cleaned – especially if it has been used a lot without regular cleaning!

What Staples Fit Ts056 Porter?

The Porter-Cable TS056 is as versatile as it is tough. This tool fires both heavy-duty 3/8 in. crown staples from 1/4 in. to 9/16 in. and 18-Gauge brad nails from 1/2 in. to 5/8 in.

Can You Use 16 Gauge Nails In A 18 Gauge Nailer?

Like 15-gauge nailers, most 16-gauge guns shoot nails up to 2-1/2 in. You’ll pay about the same for a name-brand 16-gauge nailer as you would for a 15-gauge gun. 18-gauge brad nailer. If you plan to buy only one trim nailer, this is the size to get.

How Do You Lubricate A Nail Gun?

How to oil nail gun Remove all nails. If the nailer and the air hose connection is still intact, disconnect it. Apply two to four drops of pneumatic oil into your gun. Reconnect the air hose and the nailer and proceed to pull the trigger at least five times to spread the oil through the parts of the machine.