How Do You Thread A Bobbin On A Brother Vx 1100?

Place your spool of thread on the spool pin, wind your thread from the front to the back on the thread guide, and thread it through a hole on your bobbin. Place your bobbin on the bobbin winder, hold the thread, and push the bobbin over so the winder is against the holder.

How Do You Put The Bobbin In A Brother Sewing Machine?

Turn on the sewing machine, and open the top cover. Place the bobbin on the bobbin winder shaft so that the spring on the shaft fits into the. Remove the spool cap that is inserted onto the spool pin. While holding the thread near the spool with your right hand, as shown, pull the thread with.

How Do I Adjust The Bobbin Tension On My Brother?

To adjust your bobbin thread to the correct tension, there’s a bit of trial and error to be done. First, thread your machine with a thread of normal thickness. Next, set your upper thread tension to 4 (the normal setting). Then, tighten your bobbin case tension screw.

How Do You Rethread A Bobbin?

Serger Help

Place spool of thread on spool pin. Pass thread end, from inside, through the small hole in the rim of the bobbin (illustration 2). Place bobbin onto the pin. Holding thread end, step on speed controller to run the machine until the desired amount of thread is wound. Trim thread ends from top of the bobbin.

Are Class 15 Bobbins The Same As Sa156?

SA156 Bobbins are 7/16″ depth, high quality clear plastic and are for use in many Brother sewing and embroidery machines. Do not use regular class 15 bobbins in these machines, they will cause tension problems and can damage the bobbin case.

How Do I Change The Bobbin On My Brother?

How to install the bobbin and bobbin case Using a coin or screw driver (1), remove the two screws. If a bobbin case is installed, grasp the bobbin case and then lift it out to the left. Insert the bobbin case so that the projection (1) on the bobbin case aligns with the spring (2). (1) Projection. (1) Tab.

How Do You Thread A Bobbin On A Brother Xl2610?

Place the thread on the spool pin, through the thread guide, down the right, up the left, over the hook, and down still in the left. Now thread the needle front to back. To load the bobbin, release the cover by pressing on the little square, remove the lid, and drop in the bobbin with the thread winding to the front.

How Much Thread Do You Put On A Bobbin?

If your spool pin is vertical like the one on my machine is, you might not have to worry about a spool cap. 2. Unwind about 18″ or so of thread and bring it around the backside of the bobbin winder tension disc, wind it around the tension disc one time.

How Do You Make A Bobbin?

Part 3 Winding the Bobbin Thread your bobbin. Your bobbin should have a tiny hole in the side. Find your bobbin winder. Put your bobbin on the winder. Lock your bobbin winder. Hold the end of the thread. Push down on your foot pedal. Fill up your bobbin with thread. Cut the thread.

How Do You Wind A Bobbin On A Brother Ls 2125I?

Part 1 Winding the Bobbin Place the spool on the spool pin. Pull the spool pin up so that it is completely vertical. Draw the thread through the bobbin hole. Sit the bobbin on the bobbin winding shaft. Press the foot controller. Trim the excess thread and continue winding. Cut the remaining thread.